In the last article, Henan Baichy Machinery has made a detailed analysis of the reasons for the productivity decline of the cone crusher. Next, the technical staff from Henan Baichy Machinery will tell you how to solve the problem of the productivity decline of the cone crusher.

Ø operate strictly in accordance with the instructions. This is general knowledge often stressed by Henan Baichy Machinery, The precise operation of the operator is crucial to the capacity of the equipment.It is almost the master of the capacity of a cone crusher,, therefore, the operating personnel must strictly operate the cone crusher in accordance with the instructions.

Ø Choose a professional manufacture to buy the equipment.The production technology and the capital strength of professional manufacturers are the guarantee of the quality of its cone crusher,And the equipment type and the specification are also relatively complete, customers can choose appropriate equipment according to the production demand of the enterprise and the production intensity.You can minimize the cost of investment with the large selection range.

Ø Before starting the machine, check the equipment regularly to see if there is any trouble or screw loosening, so as to ensure that the device can run without malfunction,  to avoid affecting the normal production and operation of the cone crusher.

Ø Keep the parameters of the tight edge discharge port to be constant. If you want to get stable the output, quality of sandstone products, the first thing is to ensure that the parameters of the tight edge discharge port are unchanged, otherwise, it is very easy to cause an unexpected increase in the particle size of the product, which can affect the final output of the entire production.

Ø Try to keep “full cavity” operation as long as possible.

Ø Unstable feeding will affect the grain type and the product rate,It is particularly ideal in terms of gradation and needles, and this will seriously affect the quality of the product and the capacity of the equipment. And the failure rate will be greatly reduced by maintaining a continuous “full cavity”operation.

Ø The Material drop point needs to be aligned with the center point of the feeding opening of the cone crusher.It is recommended to use the vertical guide plate to guide the feeding point to the center of the feeding opening of the cone crusher.Once the point is eccentric, the one side of the crushing chamber is full and the other side is free or less. It will bring bad affects such as the lower crusher throughput, the increase of products like needle and the products with too large size..

Ø Ensure the uniform feeding, When feeding, it is necessary to avoid the concentration of large size stones on one side, and the concentration of small size stone on the other side. Ensure that the stone materials is evenly mixed.

Ø The feeding height should not be too large. For the small , medium cone crusher, the maximum suitable height for the material falling from the feeding equipment to the feeding opening is about 0.9 meters. If the feeding height is too large,stone material is easy to "rush" into the crushing chamber at high speed, cause impact load to the cone crusher,The crushing force or power exceeds the design limit

Ø Fine material in feeding material: the stone material that are fed into the cone crusher, the particle size is equal to or less than the material which is set by the tight edge discharge port. Upon the previous experience , for two stage cone crusher, The amount of fine material in the feed should not exceed 25%; For three stage cone crusher, The amount of fine material in the feed should not exceed 10%;  

In addition, it is also necessary to maintain a cone crusher regularly, Henan Baichy Machinery reminds all users here,During the use of crusher, no matter when it is shut down or running continuously, the equipment must be lubricated and maintained to ensure that the crusher is in the best condition, and it can be put into production and operation at any time to ensure production capacity.

Prev：The reasons cause the capacity reduction of cone crusher.
Next：The introduction and process of the chrome ore beneficiation plant